webrink

Follow this to get your boot back...

http://www.gnu.org/software/grub/manual/grub.html#Installing-GRUB-natively

Once started, GRUB will show the command-line interface (see Command-line interface). First, set the GRUB's root device⁴ to the partition containing the boot directory, like this:

     grub> root (hd0,0) 

If you are not sure which partition actually holds this directory, use the command find (see find), like this:

     grub> find /boot/grub/stage1 

This will search for the file name /boot/grub/stage1 and show the devices which contain the file.

Once you've set the root device correctly, run the command setup (see setup):

     grub> setup (hd0) 

This command will install the GRUB boot loader on the Master Boot Record (MBR) of the first drive. If you want to put GRUB into the boot sector of a partition instead of putting it in the MBR, specify the partition into which you want to install GRUB:

     grub> setup (hd0,0) 

If you install GRUB into a partition or a drive other than the first one, you must chain-load GRUB from another boot loader. Refer to the manual for the boot loader to know how to chain-load GRUB.

After using the setup command, you will boot into GRUB without the GRUB floppy. See the chapter Booting to find out how to boot your operating systems from GRUB.

# posted by WebRink @ 1:22 AM